Parker D3FB is direct operated proportional directional valve, NG10 / CETOP 05 / NFPA D05 mounting footprint (ISO4401)
Two core construction variants:
✅ D3FB0: Spool & sleeve design, superior precision, low hysteresis, good repeatability
✅ D3FB3: Spool inside body design, higher nominal flow capacity
Electronic versions:
OBE (On-Board Electronics): Built-in digital driver, signal input ±10 V, 4–20 mA, ±20 mA; configurable via ProPxD software, RS232 service port
Non-OBE: Requires external digital amplifier PWD00A-400
Pressure rating
P, A, B ports: Max 350 bar
Tank T port: Max 210 bar
Nominal flow: Up to 100 L/min (ΔP=5 bar per edge)
Spool functions: Multiple spool codes, closed centre / open centre / flow characteristic options
Mechanical: Built-in manual override for commissioning; unrestricted mounting orientation
Electrical: Supply 24 VDC; protection IP65 (with proper connector fitted)
Seal: NBR standard; FKM optional for special fluids
Fluid & filtration: Mineral hydraulic oil, water-glycol on request; filtration ISO 4406 18/16/13
Temperature range: Fluid & ambient -20°C ~ +60°C
Application: Injection moulding, metal forming presses, test benches, material handling, hydraulic axis speed/position regulation, general industrial closed-loop or open-loop hydraulic control.
Brief comparison
D3FB: Direct operated proportional, NG10, open loop, economical proportional control
D31FB: Pilot operated NG10 proportional valve, higher flow
D3FP: High dynamic DFplus series, servo-grade performance, EtherCAT option
D101VA: Air pilot on-off directional valve (not proportional)
ch
English