ch
English
T 6126 EN
Electropneumatic Converter for Direct Current Signals
Type 6126 Current-to-Pressure Converter
Type 6126 Voltage-to-Pressure Converter
Application
Used to convert a direct-current input signal into a pneumatic output signal for measuring and control tasks ·
Particularly suitable as intermediate element between electric measuring devices and pneumatic controllers or between electric control devices and pneumatic control valves
Electropneumatic Converter for Direct Current Signals
The signal converter accepts a load-independent 0 to 20 mA direct-current input signal or a 0/2 to 10 V voltage signal.
Depending on the supply air pressure, the converter supplies a pneumatic output signal of 0.2 to 1 bar (3 to 15 psi) or 0.4 to 2 bar (6 to 30 psi).
The electropneumatic converter is available with either a Type 6109 or 6112 i/p Module. Type 6112 offers further output signal ranges.
Special features
• Small dimensions, low weight and rugged housing
• Excellent dynamic behavior
• Relatively large air output with low air supply consumption
• Output pressure up to 5 bar
• Central venting
• Effect of vibration is small
• Versions with reversed characteristic available (only with Type 6112 i/p Module)
• Option of connecting a pressure gauge parallel to the output
• Operation possible without an upstream pressure regulator
• Zero reset at specific mA value when switch-off electronics are activated (function can be activated as required)
• Zero point and span can be adjusted at potentiometers in devices with electronics
Versions
For non-hazardous areas:
– Type 6126-0 with electronics, i. e. switch-off electronic
function and potentiometer for zero and span
– Type 6126-0 without electronics
Notes:Not all information are shown.Contact us if you have any product-related questions.